AllyAtlas
Aviassembly official artwork, ROG Ally settings guide
SimulationJelle Booij
Verified by AllyAtlas TeamPublished Updated

AviassemblyROG Ally settings & performance

Tactile aeronautical engineering on the go.

ROG Ally Z1 Extreme · Ally X · ROG Xbox Ally X

30-second setup / Couch mode

APU power
17W
Shared VRAM
8GB
Resolution
900p
Upscaling
None (Native)
FPS target
65

The short answer

Can Aviassembly run on ROG Ally?

Aviassembly is a perfect fit for the ROG Ally, easily hitting high frame rates even at lower power profiles. We found that the physics engine is the main draw on the CPU, but the Z1 Extreme handles complex builds without breaking a sweat. You can expect a smooth 60-90 FPS at 15-25W, though the UI can feel a bit cramped on the small screen. Start on the High preset and drop the shadows if you notice any dips during massive explosions or high part counts. It is a fantastic pick for battery-conscious gaming sessions.
Your handheld
Z1 Extreme · 24GB LPDDR5X · 80Wh
Your session
A balance of clarity, power and responsive controls.

Frame pacing

65 FPS target

A steady cap over uncapped peaks.

Visuals

900p

None (Native)

Readability

Adjust UI size

UI text can be small at 1080p; use the UI Scale slider in the general settings to increase it to 1.1x or 1.2x.

Battery planning

2h 25m-2h 50m

ROG Ally X · expected playtime at 17W

Before you launch

ROG Ally X: hardware setup

Shared memory. This model shares 24GB between Windows and graphics. Extra memory gives textures more room, so raise textures before anything else. Change allocation only if the game needs it.

120Hz & VRR. Keep the built-in display at 120Hz for VRR. Below its native VRR range, low-framerate compensation can help; a 40 FPS cap keeps parries and inputs responsive.

Power & cooling. TDP is APU power, not the whole handheld’s draw. The battery range below includes display and system overhead.

Command Center & AMD quick sheet

Command Center RSR
Off
The game has None needed; use RSR if 720p is required built in. Running both makes the image soft.
AMD Anti-Lag
Enabled if available
Use the game-specific driver profile; disable it if it causes problems.
Frame generation
Off
It adds input lag in combat at this frame rate.
  1. Set Armoury Crate VRAM to 4GB.
  2. Enable Steam Input for the best controller layout experience.
  3. Ensure the Ally is in 120Hz mode to benefit from VRR during physics spikes.
Launch options & configuration
Config file · Back it up before editing%USERPROFILE%\AppData\Local\Aviassembly\Settings.json

Best Aviassembly settings for ROG Ally

ROG Ally X · Couch mode. The frame rate is a target to work toward.

FPS target
65
APU power
17W
Resolution
900p
Upscaling
None (Native)

In-game graphics

The baseline

SettingRecommendation
Overall presetMedium
Resolution1600x900
UpscalingOff
Frame generationOff
Motion blurOff

Quality & performance tuning

SettingRecommendation
Shadow QualityHeavy impactMediumDynamic shadows from complex wing structures significantly impact the GPU during flight.
Texture QualityHigh
Anti-AliasingSMAA
Ambient OcclusionOn
BloomOff

Heavy impactThese cost the most frames. Drop them first if you need more battery or higher FPS.

Start with the listed settings, then check a demanding scene before raising detail. Keep frame generation separate from the underlying frame rate when judging input response.

What to turn down first

Physics Precision vs Shadow Quality

Our pick: Physics Precision

Keep physics high for stable flight; shadows are less critical for core gameplay.

1080p Resolution vs 720p with AA

Our pick: 1080p Resolution

The UI and part edges look significantly sharper at 1080p native on this screen.

The reality check

ROG Ally vs Steam Deck: Aviassembly performance

The original Ally has 16GB shared memory and a 40Wh battery. Ally X and Xbox Ally X have 24GB and 80Wh. The extra memory gives textures more room and the bigger battery doubles session length, while the same settings profile holds across all three models.

Away from the charger

How long is your next session?

Couch mode · 17W APU power

The 900p sweet spot: 1600×900 renders about 30% fewer pixels than 1080p but stays sharp on a 7-inch screen. Add it in Armoury Crate SE’s Command Center for a one-tap switch.

Couch & plugged in

Use 25W with a charger nearby. Keep vents clear and establish a steady frame cap before raising resolution.

On the go

Try the 13W road-trip profile and lower resolution first. If combat cannot sustain the cap, use the couch profile instead of accepting uneven response.

40Wh

ROG Ally

1h 10m-1h 25m

Calculated runtime range

80Wh

ROG Ally X

2h 25m-2h 50m

Calculated runtime range

80Wh

ROG Xbox Ally X

2h 25m-2h 50m

Calculated runtime range

Uses 90% of battery capacity and 8-12W for the display and other system power. Brightness, battery wear, background apps and actual game load change runtime; TDP alone is not total power draw.

Pack & play

Small-screen comfort & travel

Give your thumbs a break

Throttle

and Brake

Right rear button

Your right thumb stays on the camera stick during fights.

Assign one action per rear button in the game’s Armoury Crate profile. Keep the default face buttons available and avoid repeated-input macros in online play.

Before you go offline

  • Finish downloads and launch the game once while connected.
  • Save, switch Steam to Offline Mode, then restart the game with Wi-Fi off.
  • Check that your save loads; online modes and launcher sign-ins may still need a connection.

Offline availability depends on the game and its launcher.

Playing tips

What to pay attention to on a handheld.

Stress spot

Testing in the main hangar with multi-engine builds or during high-speed low-altitude maneuvers will show the lowest FPS.

Heat & fans

The game is very light on hardware; the Ally stays cool and quiet even at 20W.

Small-screen reading

UI text can be small at 1080p; use the UI Scale slider in the general settings to increase it to 1.1x or 1.2x.

Shader behaviour

Uses DX11 with no significant shader compilation stuttering during gameplay.

Aviassembly ROG Ally problems & fixes

Controller not recognized

Enable Steam Input for Xbox Controllers in the Steam game properties.

UI scaling issues

Adjust the in-game UI Scale slider specifically for the 7 inch handheld screen.

Resolution reset on launch

Switch the display mode to Borderless Windowed to retain 1080p settings.

Aviassembly on ROG Ally: FAQ

Does it support touch controls?

Yes, basic part placement and menu navigation work via the touchscreen.

Is there Workshop support?

Yes, you can easily download and test community aircraft directly on the Ally.

Can I play this offline?

Absolutely, it works great for travel as long as you have your blueprints saved.

Game file

Aviassembly official logoAviassembly
Developer
Jelle Booij
Game release
12 Nov, 2026
Loading Steam activity…
Steam page

Explore more ROG Ally guides